Page 1 of 1
Staining a body
Posted: July 7th, 2012, 1:18 am
by glefty5
I'd like some advice on staining my natural Rockbass Corvette into a black stain. I'd appreciate any advice re: sanding/cutting back the current 'finish' & staining/finish coating procedures. My 1st time to try but don't wanna pay a pro as the bass isn't that expensive. Thanks brethren
Re: Staining a body
Posted: July 7th, 2012, 4:08 am
by danomite64
You probably should ask this in the 'Blueprinting and Bondo' forum.
Re: Staining a body
Posted: July 7th, 2012, 8:46 am
by andrew
Moved.
Re: Staining a body
Posted: July 14th, 2012, 12:02 pm
by Rodent
a lot will depend on the woods your body is made from. any possibility of adding a few close-up images of the top, back, and sides?
all the best,
R